Wall Mounted Dog Bowl Holder

Wall-mounted double feeder for dogs and cats — dinner up off the floor, and the floor left free to clean. Two 5.5 in (14 cm) stainless steel bowls drop into a printed bracket that fixes straight to the wall, so you pick the feeding height: low for a puppy, higher for an older dog who shouldn't have to stoop to eat. Nothing stands in the walkway, nothing slides across the tile, and a mop goes straight underneath. WHAT'S INCLUDED • One wall-mounted double bowl bracket, 3D printed in PLA • Two 5.5 in (14 cm) stainless steel bowls (on the "+ steel" option) • Wall anchors, screws and drilling instructions SIZE • Bracket: approx. 32 cm wide x 17 cm deep x 6 cm tall (12.6 x 6.7 x 2.4 in) • Bowls: 14 cm across, roughly 600 ml (20 oz) each • Suits cats, puppies, and small to medium dogs MADE TO ORDER Printed one at a time in PLA — a plant-based bioplastic — in white with a warm wood-tone front panel. Thick walls and a dense top layer where the bowls sit, so the shelf stays flat under a full bowl of water. Every one is printed after you order, so allow a few days before it ships. MOUNTING Fix into a stud wherever you can. In drywall, use both supplied anchors and keep the bracket level — the paper template marks the two holes for you. This is a feeder for cats and small to medium dogs; a large dog that leans its weight on the bowls is better served by a floor stand. CARE The steel bowls lift straight out and are dishwasher safe. Wipe the printed bracket with a damp cloth. Don't run the printed part through the dishwasher or leave it in a hot car — PLA softens with heat. Questions about height, bowl size, or colour? Message us before you order and we'll tell you straight.